If not, you may have a faulty flight controller. Hopefully by this point you have USB 3, for example, shown at the top of Configurator.
If you still don’t see a USB number other than 1, and this is the first time you have plugged a flight controller in to this computer. Sometimes using a USB hub can cause issues. Ideally, you should use a USB port on the front or back of your computer (or side of your laptop). But even decent cables can go bad over time. Some cables are just dodgy from the get-go.
The first thing I would check and change is the USB cable it’s self. If only 1 is visible, there is some communications problem. If the number is 1, check the drop down list. Secondly, we can find out which target is installed.Ĭheck the connection box at the top of configurator. Firstly, if we see activity on the flight controllers LEDs, we can see that it’s communicating with our computer, and is working. This is going to allow us to do 2 things. The first thing we are going to do is open up iNav Configurator and plug the USB cable in to our flight controller. There are a few things that we should do before one drop of solder hits our flight controllers. It’s great to plan where you’re going to put things and to test out CG. So, once we have our components, we can think about putting it all together. The Mateksys F411-WSE is a suitable replacement
Flight Controller: Mateksys F411-WING Note: this flight controller is now discontinued.Airframe: ZOHD Talon 250G PnP Note: I have no intention of keeping this under 250g.Before following this guide make sure you have installed the latest version of iNav Configurator. However, this process applies to any components that are compatible, and that you want to use. So, I have a list of components below, with links to them. While you don’t need to be using the same components that I am. This is going to be a new build from scratch. Setting up iNav 3.0’s continuous servo autotrim.Switching to the default layout in a failsafe.The INAV Fixed Wing Group OpenTX models.Setting up non-standard flight controller alignment in iNav 3.0.Testing the flight controller and finding the target.Transmitter Sound Pack: Simple phrase page generator.Propeller Blade Number Conversion Tools.iNav Stick Commands – for all transmitter modes.FrSky Receiver Compatibility Tool: Make receiver selection easy.FrSky SxR Alternative Flight Mode Switching.Five Flight Modes & Arming using One Channel.Five Flight Modes using One Radio Channel.iNav Current Sensor Calibration – the old mAh method.Adding Flaps, crow, flaperons, and more in iNav 3.0.A complete guide to setting up iNav 3.0.
0 kommentar(er)
